Publications

Austroads Technical Specification ATS 5670 sets out the requirements for the supply and installation of finger type bridge deck expansion joints, such as steel fingerplate (i.e., parallel sided fingers) or aluminium saw tooth (i.e., triangular sided…

Austroads Technical Specification ATS 5440 sets out the requirements for the fabrication of stainless steel components for bridges, gantries, roadside furniture, poles and related structures. This includes the supply of materials, preparation of…

This study relates to ongoing Austroads Project ABT6152, which seeks to verify compliance of a bridge barrier design against relevant Australian Standards that have been recently updated, and the American Association of Highway and Transportation…

The use of bonded anchors has increased significantly since the last major update of DoT Standard Specification Section 680 (Bonded Anchors) in 2016, with the commencement of Victoriaís Big Build programme over the past few years. The Big Build is…

This test method sets out the procedure for determining the apparent viscosity of PMBs at temperatures above 100°C, using the Brookfield Thermosel rotational viscometer.

This test method applies to polymer modified binders, polymers and crumb rubber.Materials are sampled according to this protocol to ensure that correct sampling procedures are followed and that test results provide the required information on…

This test method sets out the procedure for the determination of the flash point of polymer modified binders (PMBs). This test method is applicable to PMBs used in the construction and maintenance of pavements (as specified in ATS 3110).

This test method is applicable to all binders that do not have a viscous response at 70°C and at long loading times when confined to film thicknesses in the range 0.1 to 1mm. It is applicable to all modified binders.

This test method sets out the procedure for the determination of mass change or loss on heating of a polymer modified binder (PMB) due to the effect of heat and air during rolling thin film oven (RTFO) treatment.

This method complements AS/NZS 2341.21 by setting out the handling procedures for the testing of modified binders.