Publications

This report, published in January 2022, provides a basis for future testing and standardisation of the symbols and road signage for low and zero emission vehicles in Australia and New Zealand, paving the way to adopt consistent symbols in the road…

Internal combustion engine vehicles are a major source of greenhouse gas emissions in Australia and New Zealand. Encouraging the public to utilise low and zero emission vehicles (LZEVs), such as battery electric vehicles will contribute to creating…

This report details the methodology and findings of a project to develop guidance for agencies planning, installing, and operating charging infrastructure for non-commercial passenger vehicles with battery-electric or hybrid propulsion. This study…

These guidelines cover the installation of charging infrastructure for Low and Zero Emission Vehicles (LZEVs), including requirements, location, usability, and design. LZEV charging infrastructure is provided to encourage the use of LZEVs, and to…

This test method sets out the procedure for determining the apparent viscosity of PMBs at temperatures above 100°C, using the Brookfield Thermosel rotational viscometer.

This test method applies to polymer modified binders, polymers and crumb rubber.Materials are sampled according to this protocol to ensure that correct sampling procedures are followed and that test results provide the required information on…

This test method sets out the procedure for the determination of the flash point of polymer modified binders (PMBs). This test method is applicable to PMBs used in the construction and maintenance of pavements (as specified in ATS 3110).

This test method is applicable to all binders that do not have a viscous response at 70°C and at long loading times when confined to film thicknesses in the range 0.1 to 1mm. It is applicable to all modified binders.

This test method sets out the procedure for the determination of mass change or loss on heating of a polymer modified binder (PMB) due to the effect of heat and air during rolling thin film oven (RTFO) treatment.

This method complements AS/NZS 2341.21 by setting out the handling procedures for the testing of modified binders.