Publications

This work tip provides guidance on binder sampling to ensure that consistent and reliably representative samples are obtained so that any test results: represent, as near as practicable, an average of a consignment or batch

This document provides a hyperlinked list of the Austroads Test Methods and Specifications.

This method describes the procedure for the determination of the surface texture depth of road surfaces, by the sand patch technique. This method is only applicable to surface texture depths greater than 0.3 mm. This method was developed from BS…

This document describes the procedures to be followed to test an asphalt specimen using a wheel tracking test device. The procedures can be carried out on prismatic specimens that have been manufactured in the laboratory, cut from an existing…

This document describes the procedures to verify that a wheel tracking test device complies with the requirements of those devices permitted for use in Austroads test method ATM 231. The procedures are advisory rather than mandatory and reference…

The test method specifies procedures for the characterisation of the stiffness and fatigue behaviour of bituminous mixtures using a four point bending test configuration. The test procedure to characterise the complex modulus is contained in Section…

This webinar focuses on the Austroads report Passenger Cars and other Non-truck Tyres Crumb Rubber in Asphalt: National Market Analysis, Review of Industry Practices and Technology Transfer. The report provides a comprehensive overview of the fate…

This report provides a comprehensive overview of the fate of end-of-life tyres, the tyre recycling industry in Australia and New Zealand, the specifications for the use of crumb rubber in road applications and the potential benefits of other-than-…

In Australia and New Zealand, bituminous binders used in road construction are tested prior to use to ensure they will perform satisfactorily during road construction/maintenance. Some of the Australian Standards that are used for these tests have…

This seminar was held on 2 September 2022 at RMIT University in Melbourne. It was sponsored by Austroads and attracted an audience of more than 400 people across the world. The 4-hour recording considers different perspectives of incorporating waste…