Publications

This document provides a hyperlinked list of the Austroads Test Methods and Specifications.

How do drivers respond to the iconic tunnel design features included in the NorthConnex road tunnel project? What were the objectives of the designs and have the designs achieved these objectives? How do the designs affect driver behaviour? The…

This report documents the findings from a research study, which aimed to investigate driver behaviour and perceptions while driving through a simulated version of the Sydney NorthConnex (NCX) road tunnel and evaluate the effectiveness of aesthetic…

This report documents the findings from a research study which aimed to validate the use of a virtual reality (VR) driving simulator to study driving behaviour in a real road tunnel.

This method describes the procedure for the determination of the surface texture depth of road surfaces, by the sand patch technique. This method is only applicable to surface texture depths greater than 0.3 mm. This method was developed from BS…

Road users in regional and remote Australia are at a greater risk of road trauma than those living in major cities. Approximately one third of Australians live in regional or remote areas but two thirds of fatal crashes occur in these areas. The…

Information on injurious road crashes is required for prevention. National information on fatal cases has been available for many years, but information on serious non-fatal cases has been lacking. This webinar will take participants through the…

This document describes the procedures to be followed to test an asphalt specimen using a wheel tracking test device. The procedures can be carried out on prismatic specimens that have been manufactured in the laboratory, cut from an existing…

This document describes the procedures to verify that a wheel tracking test device complies with the requirements of those devices permitted for use in Austroads test method ATM 231. The procedures are advisory rather than mandatory and reference…

The test method specifies procedures for the characterisation of the stiffness and fatigue behaviour of bituminous mixtures using a four point bending test configuration. The test procedure to characterise the complex modulus is contained in Section…