Publications

This document provides a hyperlinked list of the Austroads Test Methods and Specifications.

This method describes the procedure for the determination of the surface texture depth of road surfaces, by the sand patch technique. This method is only applicable to surface texture depths greater than 0.3 mm. This method was developed from BS…

This document describes the procedures to be followed to test an asphalt specimen using a wheel tracking test device. The procedures can be carried out on prismatic specimens that have been manufactured in the laboratory, cut from an existing…

This document describes the procedures to verify that a wheel tracking test device complies with the requirements of those devices permitted for use in Austroads test method ATM 231. The procedures are advisory rather than mandatory and reference…

The test method specifies procedures for the characterisation of the stiffness and fatigue behaviour of bituminous mixtures using a four point bending test configuration. The test procedure to characterise the complex modulus is contained in Section…

This report documents the changes to Section 6 &ndash

This is the second webinar in a two-webinar series, and it covers the improvements made to the Regional Flood Frequency Estimation (RFFE) method in the Guide to Road Design Part 5.

In response to feedback provided by industry and stakeholders, Austroads has reviewed its Guide to Road Design Part 5: Drainage &ndash

The Guide to Road Design Part 5: Drainage – General and Hydrology Considerations provides road designers and other practitioners with guidance on the design of drainage systems.

The Guide to Road Design Part 5A: Drainage: Road Surface, Networks, Basins and Subsurface, provides road designers and other practitioners with guidance on the design of the collection and discharge of water from road surfaces, pit and pipe systems,…