Publications

Structural analysis has progressed a long way from hand calculations and the use of distribution factors. From the first computer methods, grid and grillage analysis techniques evolved, leading through progressive enhancements to the advanced 3D…

Some old bridges in Australia were constructed with a deck system consisting of non-composite concrete slab over steel girders. The paper herein presents the methodology for structural retrofitting/ strengthening of these existing bridges based on…

The economic vitality of Auckland depends upon the movement of people and freight around the city’s motorways and the Auckland Harbour Bridge (AHB) is a crucial component of the network. Traffic loads derived from weigh-in-motion (WIM) data measured…

There are 5094 bridges and bridge size culverts under the jurisdiction of the Roads and Traffic Authority (RTA) NSW. More than 50% of these bridges were built before 1976 and design load was significantly lower than the T44 design load in accordance…

More sustainable bridge infrastructure can be achieved by eliminating costly and unnecessary replacement or overly zealous upgrading of ageing bridges. Estimates of current safety of bridges or their remaining service life are critically dependent…

This report summarises work conducted to establish a compaction procedure for the Austroads asphalt mix design process. Part of the early work examined overseas research and this is briefly summarised to provide supporting evidence as to the…

The Austroads asphalt mix design method was developed in 1997 and has had a number of revisions over the intervening years as test methods evolve and experience is gained. However, implementation of the method has been variable across the various…

This report summarises some of the literature dealing with the compaction of dense graded asphalt. Compaction of asphalt is usually expressed in terms of air void content. This is necessary as the aggregate which constitutes about 95% of the mass of…

The development of an Austroads asphalt mix design procedure led to adaptation and adoption of a number of overseas test methods. These test methods were then compiled into what has become a suite of Austroads test methods. The Austroads test…

This report presents a review of the available structural design methods for foamed bitumen pavements, as a first step in the development of thickness design procedures. Six design procedures were found in the literature, most of them based on well…