Publications

This report is an update of earlier Austroads sprayed seal design procedures based on the philosophy of filling voids in the aggregate matrix with binder to a depth of about one half to two thirds the height of the aggregate when laying on its least…

This report gives information on the development of a procedure to fractionate bitumen using an Iatroscan liquid chromatography system, and also presents test results on a range of Australian bitumens. An introduction discusses the topic of bitumen…

This Supplement is intended to assist those required to plan and design new pavements for lightly trafficked situations. It caters for design traffic up to 105 ESA for flexible pavements and 106 Heavy Vehicle Axle Groups for rigid pavements. It is a…

The purpose of this document is to deliver consistency of enforcement practices across jurisdictions, improve compliance with road transport law, and deliver greater road safety outcomes and asset protection. It is intended to provide guidance to…

The purpose of this document is to provide administrative guidelines that are consistent with the national model Road Transport Reform (Compliance and Enforcement) Bill (the

This Specification Framework for Polymer Modified Binders (PMBs) and Multigrade Bitumens has been produced by an Austroads Project Group. The specification is based on a set of test procedures that have been in use throughout Australia for several…