Publications

This work tip provides guidance on binder sampling to ensure that consistent and reliably representative samples are obtained so that any test results: represent, as near as practicable, an average of a consignment or batch

Road users in regional and remote Australia are at a greater risk of road trauma than those living in major cities. Approximately one third of Australians live in regional or remote areas but two thirds of fatal crashes occur in these areas. The…

Information on injurious road crashes is required for prevention. National information on fatal cases has been available for many years, but information on serious non-fatal cases has been lacking. This webinar will take participants through the…

Austroads Project APT6305 Use of Road-grade Recycled Plastics for Sustainable Asphalt Pavements is investigating the use of recycled plastics in asphalt. The project is almost completed with results to date provided in three published reports. The…

This report is the third of a series of reports for project APT6305. The first report examined the use of road-grade recycled plastics in asphalt pavements and investigated the most suitable types of recycled plastics for incorporation into asphalt.…

The purpose of this literature review is to assess the current body of research for the incorporation of recycled material in pavements to inform updated guidance to the current Austroads Guide to Pavement Technology Part 4E: Recycled Materials. New…

This webinar, presented by Dr Negin Zhalehjoo, Andrew Papacostas and Dr Didier Bodin, focuses on the outcomes of an Austroads research project &ldquo

This method describes the procedure for obtaining a measure of the evenness of a pavement surface as determined by the deviation from a three metre straightedge. It is applicable only to the measurement of depressions in the pavement surface and to…

This test method sets out procedures for the preparation of asphalt specimens and measuring the change in indirect tensile strength resulting from the effects of moisture and freeze/thaw conditioning. The results can be used to assess the propensity…

The characterisation of the flexural stiffness and fatigue behaviour of bituminous mixtures in Australia and New Zealand is undertaken using a four-point bending (4PB) configuration. This document describes the procedures to be followed to verify…