Publications

This Pavement Work Tip provides information on the essential elements of the calibration process for bitumen sprayers.

This Pavement Work Tip details the general principles affecting aggregate size selection and provides recommended aggregate sizes for a range of sealing treatments.

This Pavement Work Tip outlines the procedure to allow for surface texture variations by pre-spraying of additional binder.

This Pavement Work Tip provides instructions on how to minimise sprayed sealing handwork and gives some suggestions for maximising the use of a sprayer when sealing tapers and roundabouts.

This Pavement Work Tip describes the requirements for the selection of an appropriate design aggregate spread rate and the calibration of aggregate spreading equipment for uniformity and consistency of output.

This Pavement Work Tip refers to minimising the risk of bleeding when carrying out sprayed sealing work during extreme hot weather events, especially when subject to slow moving or stationary heavy traffic, or unusually heavy loads.

This report details of the performance of polymer modified binder (PMB) trial sites in South Australia and New South Wales after 12 months service life. It includes related information such as the seal designs, binder testing in the laboratory, site…

This report presents the results of a literature review and laboratory study which was conducted as part of the development of a new-long term ageing (durability) test for bituminous binders used in sprayed seals in Australia.

The literature review…

This report describes the planning and construction of Australian field trials which will measure of the relative performance of polymer modified binders (PMBs) used in strain alleviating membranes in sprayed bituminous sealing. Issues addressed in…

This Pavement Work Tip is a guide to the use of cutter oils in hot PMB binders used in sprayed sealing work.