Publications

This document describes the procedures to be followed to test an asphalt specimen using a wheel tracking test device. The procedures can be carried out on prismatic specimens that have been manufactured in the laboratory, cut from an existing…

This document describes the procedures to verify that a wheel tracking test device complies with the requirements of those devices permitted for use in Austroads test method ATM 231. The procedures are advisory rather than mandatory and reference…

The test method specifies procedures for the characterisation of the stiffness and fatigue behaviour of bituminous mixtures using a four point bending test configuration. The test procedure to characterise the complex modulus is contained in Section…

This test method describes the procedure for determining the cone penetration of a joint sealant at 25 

This test method describes the procedure for determining the resistance of hot poured joint sealants to flow at a temperature of 70 °

This test method sets out the procedure to be used to prepare joint sealant samples for testing.

This test method describes the procedure for determining the degree to which a joint sealant is degraded by heat during prolonged storage (6 

The test method outlines the procedure for determining the permeability of a water-saturated asphalt specimen in the laboratory using the ponding method. The test method was primarily developed for dense-graded, stone mastic and gap-graded asphalt…