Publications

Austroads test method 710 describes the procedure for determining the chloride content of select backfill material intended for use in reinforced earth structures. Chloride content is determined by water extraction and titrimetric analysis of the…

This test method describes the procedure for determining the cone penetration of a joint sealant at 25 

This test method describes the procedure for determining the resistance of hot poured joint sealants to flow at a temperature of 70 °

This test method sets out the procedure to be used to prepare joint sealant samples for testing.

This test method describes the procedure for determining the degree to which a joint sealant is degraded by heat during prolonged storage (6 

This test method sets out the procedure for determining the apparent viscosity of PMBs at temperatures above 100°C, using the Brookfield Thermosel rotational viscometer.

This test method applies to polymer modified binders, polymers and crumb rubber.Materials are sampled according to this protocol to ensure that correct sampling procedures are followed and that test results provide the required information on…

This test method sets out the procedure for the determination of the flash point of polymer modified binders (PMBs). This test method is applicable to PMBs used in the construction and maintenance of pavements (as specified in ATS 3110).

This test method is applicable to all binders that do not have a viscous response at 70°C and at long loading times when confined to film thicknesses in the range 0.1 to 1mm. It is applicable to all modified binders.

This test method sets out the procedure for the determination of mass change or loss on heating of a polymer modified binder (PMB) due to the effect of heat and air during rolling thin film oven (RTFO) treatment.