Publications

This test method applies to polymer modified binders, polymers and crumb rubber.Materials are sampled according to this protocol to ensure that correct sampling procedures are followed and that test results provide the required information on…

This test method sets out the procedure for the determination of the flash point of polymer modified binders (PMBs). This test method is applicable to PMBs used in the construction and maintenance of pavements (as specified in ATS 3110).

This test method is applicable to all binders that do not have a viscous response at 70°C and at long loading times when confined to film thicknesses in the range 0.1 to 1mm. It is applicable to all modified binders.

This test method sets out the procedure for the determination of mass change or loss on heating of a polymer modified binder (PMB) due to the effect of heat and air during rolling thin film oven (RTFO) treatment.

This method complements AS/NZS 2341.21 by setting out the handling procedures for the testing of modified binders.

This test method sets out the procedure for the determination of torsional recovery of polymer modified binders (PMBs) under specific conditions using a simple torsional recovery test apparatus. PMBs are thought to provide benefits due to their…

This method describes the procedure for obtaining a measure of the evenness of a pavement surface as determined by the deviation from a three metre straightedge. It is applicable only to the measurement of depressions in the pavement surface and to…

This test method sets out procedures for the preparation of asphalt specimens and measuring the change in indirect tensile strength resulting from the effects of moisture and freeze/thaw conditioning. The results can be used to assess the propensity…

The characterisation of the flexural stiffness and fatigue behaviour of bituminous mixtures in Australia and New Zealand is undertaken using a four-point bending (4PB) configuration. This document describes the procedures to be followed to verify…

The test method outlines the procedure for determining the permeability of a water-saturated asphalt specimen in the laboratory using the ponding method. The test method was primarily developed for dense-graded, stone mastic and gap-graded asphalt…