Publications

This webinar, presented on 13 November 2018, outlines the strategic context on the supply of road operator data for connected and automated vehicles use in Australia, and the recommended next steps to navigate through this developing field.

This webinar, presented on 25 September 2018, presents challenges around the introduction of automated heavy vehicles to remote and regional areas and the opportunities for future their use in Australia and New Zealand.

This report identifies opportunities for future use of automated heavy vehicles in regional and remote areas of Australia and New Zealand, as well as any boundaries to prevent such use. The report provides road managers and industry with direction…

This report sets out the strategic context for the supply of road operator data for use by Connected and Automated Vehicles (CAVs) in Australia and includes recommended next steps.CAVs are anticipated to rely heavily on data from their sensors for…

This webinar, presented on 3 July 2018, provides an overview of the progress and key lessons learnt from three major Connected and Automated Vehicles (CAV) trials in Australia. It covers: ARRB/ConnectEast/VicRoads development of road certification…

This protocol specifies the method for sampling bituminous slurry mixture from the slurry paving unit at the paving site.

This test method sets out the procedure to evaluate the wearing resistance of bituminous slurry surfacing materials under wet abrasion conditions.

This test method sets out the procedure to evaluate bituminous slurry materials for their propensity for binder flushing after subjecting to loaded wheel tracking cycles.

This test method sets out the method for the determination of the setting and curing characteristics of a bituminous slurry as a function of the cohesive strength developed in the mixture with time.

This test method sets out the procedure to determine the consistency of a bituminous slurry that is then used to optimise the amount of water required to form a workable mixture. This test may not be applicable to certain microsurfacing mixtures due…