Publications

This report describes research into development of a laboratory sprayed seal binder cracking test which can be used to measure the relative fatigue cracking resistance of thin binder films which have thicknesses comparable to the thicknesses of the…

This report examines the capacity of the extra-large wheel-tracking laboratory test method to predict the in-service performance of granular materials.

Rutting is a common distress mode of unbound granular bases under thin bituminous surfacings.

Five…

EME2 mixes are produced using a hard paving grade bitumen applied at a high binder content (approximately 6%). Compared to conventional asphalt bases with unmodified binders, EME2 asphalt is characterised by high stiffness, high durability, superior…

This report examines the selection of an appropriate laboratory compaction device for stone mastic asphalt (SMA). The laboratory compaction of the SMA mix is crucial as the volumetric properties are selected based on the results from laboratory…

This study investigated the potential introduction of the French high modulus hot mix asphalt technology, called enrobés à module élevé (EME) to Australia. The EME mix technology provides a high performing asphalt material for use in heavy duty…

This report documents a study designed to predict temperature and load frequency in asphalt pavements and their effect on the modulus of the asphalt material. It is the first report from a three-year Austroads project which aims to improve the…

This report presents the findings from the first year of a three year Austroads study which aims to maximise the re-use of reclaimed asphalt pavement (RAP) in new asphalt product. The objective of this first year of study is to improve the…

This document is an update of the design procedure for double/double sprayed seal surfacing. The information supersedes that in Update of the Austroads Sprayed Seal Design Method(Austroads 2006), and replaces Sections 6, 7 and 8 in that document.

…

This report presents details of a Warm Mix Asphalt (WMA) Evaluation Protocol. The Protocol guides the evaluation of specific WMA technologies and processes such as additives, surfactants and foamed bitumen, and sets out the conduct of appropriate…

This report presents the results of the laboratory testing program conducted in support of the validation trial of warm mix asphalt (WMA) and hotmix asphalt (HMA) conducted in Melbourne, Australia, between 2010 and 2012. Although the intention was…