Publications

This report details the experimental program, analysis and findings of the assessment of the impacts of axle mass increases on road deterioration for sprayed seal surfaced unbound granular pavements. Load-damage exponents ranged between two and four…

This document describes the results of field trials held in Christchurch, New Zealand in May 2005. The objective of the trials was to gain further understanding of the complex relationship between the various test devices currently utilised to…

This test method sets out the procedure for determining the amount of binder drain-off likely to occur in an asphalt mix during storage and transport. The method may be used to determine the amount of binder drain-off at the maximum mixing…

This method describes the procedure for the recovery of sprayed seal samples from the pavement without disturbing the sealing aggregate orientation. The method stipulates how the void content of the sample is determined.

This test method sets out the procedure for assessing the degree of absorption of a primer or primerbinder by a given road gravel in bituminous surfacing work.

Selection of maintenance techniques is always a balance between the administering authority costs and social and environmental costs and outcomes. This project provides practical information and a methodology (including a worked example) for…

This test method details the requirements for determining the flexural stiffness, phase angle, dissipated energy per cycle, cycles to failure and cumulative dissipated energy at failure of asphalt subjected to repeated flexure by cyclical four-point…

A general literature survey and a user survey was conducted to obtain information on existing data aggregation methods and their status in Australia and New Zealand. The responses to the survey indicated that all agencies use or are close to…

An existing model predicted binder life by combining a binder hardening (increase in viscosity) model and a distress viscosity model. Inputs for the two models were site temperature parameters, binder durability (resistance to hardening) and seal…

An existing model predicted maximum seal life by combining a binder hardening (increase in viscosity) model and a distress viscosity model. Inputs for the two models were site temperature parameters and binder durability (resistance to hardening).…