Publications

This document provides a hyperlinked list of the Austroads Test Methods and Specifications.

This test method describes the procedure for determining the cone penetration of a joint sealant at 25 

This test method describes the procedure for determining the resistance of hot poured joint sealants to flow at a temperature of 70 °

This test method sets out the procedure to be used to prepare joint sealant samples for testing.

This test method describes the procedure for determining the degree to which a joint sealant is degraded by heat during prolonged storage (6 

This method sets out the procedure for determining the degree of stripping of a single coat sprayed seal with a nominal aggregate size of 10 mm or larger.

This test method provides an overview of the 

This test method is for bitumen sprayers as specified in AGPT/T530 Calibration of bitumen sprayers: 

This test method sets out the procedure for validating the calibration fluid. The calibration fluid is used for volumetric calibration of bitumen sprayer pumps (AGPT/T531), and also for two methods of determining transverse distribution of bitumen…

This test method is for bitumen sprayers as specified in AGPT/T530 Calibration of bitumen sprayers: general introduction and list of methods. It sets out the procedures for determining the transverse distribution of bitumen sprayers, and is based on…