Publications

Polymer modified binders (PMBs) are increasingly used in road construction as they provide enhanced performance properties compared with conventional bitumen. Even though PMBs show enhanced service properties, they may show degradation or changes in…

This report presents the results of a laboratory study that was conducted as part of the development of a new-long term ageing (durability) test for bituminous binders used in sprayed seals in Australia.

Among the number of test methods reviewed and…

This Pavement Work Tip provides a handy summary of the Austroads AP-T235-13 Guide to the Selection and use of Polymer Modified Binders and Multigrade Bitumens.

Stabilisation may be defined as a process by which the intrinsic properties of a pavement material are altered by the addition of a stabilisation binder to meet performance expectations in its operating, geological and climatic environment. Part 4L…

A road trial was established at Gisborne on the Calder Highway. The aim of the trial was to review the performance of sprayed seals constructed from a number of binder types. Class 170 is typically used in Victoria for sprayed seals and a section…

Austroads has produced a series of test methods developed from various technical projects, principally in the bituminous materials area (asphalt, binders, slurry and sprayed seals). The Austroads system of managing the test methods has enabled…

This Specification Framework for Polymer Modified Binders (PMBs) and Multigrade Bitumens has been produced by an Austroads Project Group. The specification is based on a set of test procedures that have been in use throughout Australia for several…

A residential workshop on quality management in Durban, South Africa covered a number of subjects including refinery processes, bitumen and PMB manufacture, overseas trends in bitumen and PMB specifications, test methods, global quality management…

An existing model predicted binder life by combining a binder hardening (increase in viscosity) model and a distress viscosity model. Inputs for the two models were site temperature parameters, binder durability (resistance to hardening) and seal…