Publications

This document provides a hyperlinked list of the Austroads Test Methods and Specifications.

Austroads has completed a project to replace the obsolete gyratory compactors used in design and quality control testing of asphalt mixes and update its Guide to Pavement Technology Part 4B: Asphalt. Austroads asphalt mix design procedure currently…

This method describes the procedure for the determination of the surface texture depth of road surfaces, by the sand patch technique. This method is only applicable to surface texture depths greater than 0.3 mm. This method was developed from BS…

The asphalt industry is rapidly evolving, and it is widely accepted that prescriptive specifications are not necessarily well suited to take full advantage of the benefits that new and innovative technologies can provide. There is therefore a desire…

This document describes the procedures to be followed to test an asphalt specimen using a wheel tracking test device. The procedures can be carried out on prismatic specimens that have been manufactured in the laboratory, cut from an existing…

This document describes the procedures to verify that a wheel tracking test device complies with the requirements of those devices permitted for use in Austroads test method ATM 231. The procedures are advisory rather than mandatory and reference…

The test method specifies procedures for the characterisation of the stiffness and fatigue behaviour of bituminous mixtures using a four point bending test configuration. The test procedure to characterise the complex modulus is contained in Section…

This report documents the delivery of the first component of a new Austroads performance-related asphalt specification framework. This included the development of several new test methods and updating a number of existing test methods for use in…

Transport for New South Wales (TfNSW) QA Specification B80 'Concrete work for Bridge' (TfNSW B80)10 has seen continual improvement over the years. These improvements adopted recent industry trends and new technologies including self-compacting…

In attempts to reduce the CO2 footprint of the construction industry, technologies have been developed in the past for the replacement of Portland cement by other materials, such as supplementary cementitious materials (SCMs), which have had the…