Publications

This document provides a hyperlinked list of the Austroads Test Methods and Specifications.

This method describes the procedure for the determination of the surface texture depth of road surfaces, by the sand patch technique. This method is only applicable to surface texture depths greater than 0.3 mm. This method was developed from BS…

For over a decade, the National Telematics Framework has been setting a benchmark as an effective regulatory framework for optimised vehicle movements, making Australia a world-leader in intelligent access management. The National Telematics…

Between December 2023 and September 2024, Telstra, Optus and Vodafone will close their 3G networks to make room for new, faster services. The 3G network shutdown will affect vital equipment and services across the road transport sector. Devices that…

Transport for NSW (TfNSW) is transitioning from Interim On-Board Mass (OBM) management to Smart OBM. All Performance Based Standards (PBS) vehicle operators with mass monitoring as a condition of access will need to transition to the more advanced…

This document describes the procedures to be followed to test an asphalt specimen using a wheel tracking test device. The procedures can be carried out on prismatic specimens that have been manufactured in the laboratory, cut from an existing…

This document describes the procedures to verify that a wheel tracking test device complies with the requirements of those devices permitted for use in Austroads test method ATM 231. The procedures are advisory rather than mandatory and reference…

The test method specifies procedures for the characterisation of the stiffness and fatigue behaviour of bituminous mixtures using a four point bending test configuration. The test procedure to characterise the complex modulus is contained in Section…

This test method is used to measure the ability of a concrete with a maximum coarse aggregate size of 20 mm or less to retain its water under pressure. This test determines the amount of water de-filtered when concrete is subjected to a certain…

Austroads Technical Specification ATS 5315 sets out the requirements for the supply of Special Class Concrete used in: bridges with a design life of 100 years