Publications

This report details road and transport safety interventions that can reduce fatal and serious injury crashes in regional and remote areas. It contains the factsheets, prioritisation framework, and evaluation framework from the report Practical…

This document provides a hyperlinked list of the Austroads Test Methods and Specifications.

This method describes the procedure for the determination of the surface texture depth of road surfaces, by the sand patch technique. This method is only applicable to surface texture depths greater than 0.3 mm. This method was developed from BS…

Supplements have provided important additional guidance to the Austroads Guide to Road Design (Guide). But there are questions about their use. Are these supplements needed? What should they contain? Should the information in the agency supplements…

This report details road and transport safety interventions that can reduce fatal and serious injury crashes in regional and remote areas. A literature review expands on the Austroads National View on Regional and Remote Road Safety report by…

This report is one of the two reports that document the findings of a research project undertaken to update the Austroads Guide to Road Design (AGRD). The project reviewed the jurisdictional practices of developing supplements to the AGRD to…

This report is one of the two reports that document the findings of a research project undertaken to update the Austroads Guide to Road Design (AGRD). The project reviewed the jurisdictional practices of developing supplements to the AGRD to…

This document describes the procedures to be followed to test an asphalt specimen using a wheel tracking test device. The procedures can be carried out on prismatic specimens that have been manufactured in the laboratory, cut from an existing…

This document describes the procedures to verify that a wheel tracking test device complies with the requirements of those devices permitted for use in Austroads test method ATM 231. The procedures are advisory rather than mandatory and reference…

The test method specifies procedures for the characterisation of the stiffness and fatigue behaviour of bituminous mixtures using a four point bending test configuration. The test procedure to characterise the complex modulus is contained in Section…