Publications

Filter
Publication State
Showing 1 - 10 of 71 Publications
Validation of Revised Austroads Sprayed Seal Design Approaches: Site Inspection

This report details investigations that were conducted to verify the new Austroads sprayed seal design guidelines.

To verify the appropriateness of the proposed basic voids factor (Vf), and the initial sealing design approach (and also to validate…

Development of a Sprayed Seal Binder Cracking Test

This report describes research into development of a laboratory sprayed seal binder cracking test which can be used to measure the relative fatigue cracking resistance of thin binder films which have thicknesses comparable to the thicknesses of the…

Citylink Tulla Widening Project English Street Bridge Demolition and Construction
As part of the CityLink Tulla Widening (CTW) project, the English Street Bridge will be reconstructed to accommodate the widened Tullamarine Freeway and improve access to Essendon Fields. The reconstructed English Street Bridge will be a single span…
Strengthening of Bridges for Higher Productivity Freight Vehicles
Currently there is pressure from the freight industry to allow higher performance freight vehicles (HPFV) the use of major transport routes, particularly between the major centres of Brisbane, Melbourne and Sydney. An initial review of the existing…
2017 Revision of Australian Standard AS 5100 Part 2: Design Loads
Part 2 Design loads of Australian Standard AS 5100 Bridge design sets out the parameters for loads on all bridges in Australia. There have been numerous enhancements to improve the scope, clarity and intent. Design loads for road traffic barriers…
Strengthening and Widening of the Maribyrnong River Bridges
The Maribyrnong River Bridges (also known as E.J. Whitten Bridge), is Victoria’s second largest road bridge being a 520 m long ten span structure that carries the M80 Ring Road over the Maribyrnong River in the outer western suburbs of Melbourne.…
Angellala Creek Bridge: Explosion to Bridge Reconstruction with a BIM Future
On the night of 5th September 2014 a road-train transporting 52 tonnes of ammonium nitrate crashed next to the Angellala Creek Bridge. The bridge is approximately 30km south of Charleville, on the Mitchell Highway in outback Queensland. The incident…
Design and Construction of Rail Grade Separations for an Accelerated Construction Program
The Level Crossing Removal Project Package 1 (LCRP1) has successfully achieved its goal in Connecting Communities through the removal of four level crossings in record time by lowering the rail under road. The simultaneous removal of three of these…
2017 Revision of Australian Standard AS 5100 Part 1: Scope and General
AS 5100 is the only Australian standard specific to bridges. For the first time, the scope has been extended from primarily a structural design standard to include other bridge related topics including safety-in-design, climate change and…
Bridge Design Challenges on the Waikato Expressway Huntly Section, New Zealand
The Huntly Section is a new NZ$415M section of the Waikato Expressway running between Hamilton and Auckland. It will connect the recently completed Ngaruawahia and Ohinewai sections on a route that traverses the Taupiri Ranges within a deep cutting…