Publications

Guide to Pavement Technology Part 2: Pavement Structural Design provides advice for the structural design of sealed road pavements. The advice has been generally developed from the approaches followed by the Austroads member agencies. However, as it…

This report details the testing of 21 Austroads jurisdictions mixes and one airport mix to develop a relationship between the Austroads Gyropac Gyratory compactor, which is now redundant, and the Servopac (setup to AS/NZS) and Superpave Gyratory…

Following previous workforce capability studies undertaken in 2006, 2009, 2013 and 2017, Austroads engaged Oxford Economics Australia to undertake a new workforce capability analysis for member authorities based on planned and forecasted…

This report evaluates the skills and capabilities required by Austroads member agencies in the next decade to achieve their service objectives. It compares these requirements with the current and projected future workforce, identifies potential…

This Pavement Work Tip provides information on the essential elements of the calibration process for bitumen sprayers.

This Pavement Work Tip details the general principles affecting aggregate size selection and provides recommended aggregate sizes for a range of sealing treatments.

This Pavement Work Tip outlines the procedure to allow for surface texture variations by pre-spraying of additional binder.

This Pavement Work Tip provides instructions on how to minimise sprayed sealing handwork and gives some suggestions for maximising the use of a sprayer when sealing tapers and roundabouts.

This Pavement Work Tip describes the requirements for the selection of an appropriate design aggregate spread rate and the calibration of aggregate spreading equipment for uniformity and consistency of output.

This Pavement Work Tip refers to minimising the risk of bleeding when carrying out sprayed sealing work during extreme hot weather events, especially when subject to slow moving or stationary heavy traffic, or unusually heavy loads.