Publications

This report describes a literature review on the permeability of sprayed seal surfacings. This review work was conducted to explore the permeability limits of sprayed seal surfacings, and to determine the influencing factors which allow seals to…

This document is an update of the design of initial treatments for sprayed seal surfacing.

The information contained within this document supersedes that found in Austroads AP-T68-06 Update of the Austroads Sprayed Seal Design Method, and replaces…

The principal aim of this work was to examine the effect of heavy vehicle loading on sprayed seals, in order to incorporate such loading impacts into the Austroads sprayed seal design method.

The current sprayed seal design method uses an equivalent…

This publication reports the literature review and statistical analysis stages of a project to investigate the relationship between disadvantage and road casualties.

Pedestrians account for around 14% of Australian road deaths annually. International research suggests that pedestrian distraction from smart phones may lead to greater risk of trauma. Ownership of smart phones in Australia is high, suggesting this…

This report is an update of earlier Austroads sprayed seal design procedures based on the philosophy of filling voids in the aggregate matrix with binder to a depth of about one half to two thirds the height of the aggregate when laying on its least…

Austroads has produced a series of test methods developed from various technical projects, principally in the bituminous materials area (asphalt, binders, slurry and sprayed seals). The Austroads system of managing the test methods has enabled…

An Austroads national workshop on sprayed sealing was held to assist development of a research program and identify challenges to the future use of seals. Delegates identified key issues under the themes of: safety and traffic management

An existing model predicted binder life by combining a binder hardening (increase in viscosity) model and a distress viscosity model. Inputs for the two models were site temperature parameters, binder durability (resistance to hardening) and seal…

An existing model predicted maximum seal life by combining a binder hardening (increase in viscosity) model and a distress viscosity model. Inputs for the two models were site temperature parameters and binder durability (resistance to hardening).…