Publications

Road users in regional and remote Australia are at a greater risk of road trauma than those living in major cities. Approximately one third of Australians live in regional or remote areas but two thirds of fatal crashes occur in these areas. The…

Information on injurious road crashes is required for prevention. National information on fatal cases has been available for many years, but information on serious non-fatal cases has been lacking. This webinar will take participants through the…

This Pavement Work Tip provides information on the essential elements of the calibration process for bitumen sprayers.

This Pavement Work Tip details the general principles affecting aggregate size selection and provides recommended aggregate sizes for a range of sealing treatments.

This Pavement Work Tip outlines the procedure to allow for surface texture variations by pre-spraying of additional binder.

This Pavement Work Tip provides instructions on how to minimise sprayed sealing handwork and gives some suggestions for maximising the use of a sprayer when sealing tapers and roundabouts.

This Pavement Work Tip describes the requirements for the selection of an appropriate design aggregate spread rate and the calibration of aggregate spreading equipment for uniformity and consistency of output.

This Pavement Work Tip refers to minimising the risk of bleeding when carrying out sprayed sealing work during extreme hot weather events, especially when subject to slow moving or stationary heavy traffic, or unusually heavy loads.

This linked index of the Pavement Work Tips is designed to help practitioners easily access the more than 50 publications in the Work Tips collection.

This test method describes the procedure for determining the cone penetration of a joint sealant at 25