Publications

This webinar presents the work involved in developing a standardised comparative risk assessment method for assessing life safety risk of dangerous goods being routed through the tunnel or via an alternative surface route.

This report is one of the three reports produced as part of a project undertaken to establish a comparative risk assessment method for assessing whether a tunnel route is safer than a surface route for the road transit of dangerous goods (DG)…

This report is one of the three reports produced as part of a project undertaken to establish a comparative risk assessment method for assessing whether a tunnel route is safer than a surface route for the road transit of dangerous goods (DG)…

This report is the second of the three reports produced as part of a project undertaken to establish a comparative risk assessment method for assessing whether a tunnel route is safer than a surface route for the road transit of dangerous goods (DG)…

This Pavement Work Tip provides information on the essential elements of the calibration process for bitumen sprayers.

This Pavement Work Tip details the general principles affecting aggregate size selection and provides recommended aggregate sizes for a range of sealing treatments.

This Pavement Work Tip outlines the procedure to allow for surface texture variations by pre-spraying of additional binder.

This Pavement Work Tip provides instructions on how to minimise sprayed sealing handwork and gives some suggestions for maximising the use of a sprayer when sealing tapers and roundabouts.

This Pavement Work Tip describes the requirements for the selection of an appropriate design aggregate spread rate and the calibration of aggregate spreading equipment for uniformity and consistency of output.

This Pavement Work Tip refers to minimising the risk of bleeding when carrying out sprayed sealing work during extreme hot weather events, especially when subject to slow moving or stationary heavy traffic, or unusually heavy loads.