Publications

This Pavement Work Tip provides information on the essential elements of the calibration process for bitumen sprayers.

This Pavement Work Tip details the general principles affecting aggregate size selection and provides recommended aggregate sizes for a range of sealing treatments.

This Pavement Work Tip outlines the procedure to allow for surface texture variations by pre-spraying of additional binder.

This Pavement Work Tip provides instructions on how to minimise sprayed sealing handwork and gives some suggestions for maximising the use of a sprayer when sealing tapers and roundabouts.

This Pavement Work Tip describes the requirements for the selection of an appropriate design aggregate spread rate and the calibration of aggregate spreading equipment for uniformity and consistency of output.

This Pavement Work Tip refers to minimising the risk of bleeding when carrying out sprayed sealing work during extreme hot weather events, especially when subject to slow moving or stationary heavy traffic, or unusually heavy loads.

This Pavement Work Tip is a practical guide to sprayed sealing in areas where a pavement may be affected by drought or salt content in its construction.

This report presents an extensive literature review of pavement surface texture measurement methods with a specific interest in how they affect operator safety and delays to traffic. The literature review shows that there are a number of methods in…

In 1993, Austroads performed an extensive trial of foamed bitumen sprayed sealing in Australia, as a part of environmental and energy effective sealing technology development program. The trials were conducted in various states and reported to be…

A review of bleeding or flushed seals was undertaken to determine what physical changes had taken place within the seal that had resulted in the binder lying at or close to the surface. The evaluation process used a visual appraisal and a digital…