Publications

This Pavement Work Tip provides information on the essential elements of the calibration process for bitumen sprayers.

This Pavement Work Tip details the general principles affecting aggregate size selection and provides recommended aggregate sizes for a range of sealing treatments.

This Pavement Work Tip outlines the procedure to allow for surface texture variations by pre-spraying of additional binder.

This Pavement Work Tip provides instructions on how to minimise sprayed sealing handwork and gives some suggestions for maximising the use of a sprayer when sealing tapers and roundabouts.

This Pavement Work Tip describes the requirements for the selection of an appropriate design aggregate spread rate and the calibration of aggregate spreading equipment for uniformity and consistency of output.

This Pavement Work Tip refers to minimising the risk of bleeding when carrying out sprayed sealing work during extreme hot weather events, especially when subject to slow moving or stationary heavy traffic, or unusually heavy loads.

Flexible granular pavements protected by sprayed seal surfacings are the backbone of the Australian and New Zealand road networks. Road agencies in Australia and New Zealand have therefore been focused on producing quality, long-lasting sprayed seal…

This report presents the findings of site inspections and binder ageing performance studies associated with two Austroads sprayed seal trial sites constructed near Coober Pedy, South Australia and Cooma, New South Wales. These trials were…

This method sets out the procedure for determining the degree of stripping of a single coat sprayed seal with a nominal aggregate size of 10 mm or larger.