Publications

This document provides a hyperlinked list of the Austroads Test Methods and Specifications.

This method describes the procedure for the determination of the surface texture depth of road surfaces, by the sand patch technique. This method is only applicable to surface texture depths greater than 0.3 mm. This method was developed from BS…

This document describes the procedures to be followed to test an asphalt specimen using a wheel tracking test device. The procedures can be carried out on prismatic specimens that have been manufactured in the laboratory, cut from an existing…

This document describes the procedures to verify that a wheel tracking test device complies with the requirements of those devices permitted for use in Austroads test method ATM 231. The procedures are advisory rather than mandatory and reference…

The test method specifies procedures for the characterisation of the stiffness and fatigue behaviour of bituminous mixtures using a four point bending test configuration. The test procedure to characterise the complex modulus is contained in Section…

This report documents the best practice approaches for the use of road tunnel wall panels and finishes, which informed the development of a specification framework. This was developed through a workshop with subject-matter experts, review of current…

This report, originally published in November 2021, outlines the findings of a project to develop clearer and more consistent tunnel signage to reduce the impact of over-dimensioned and dangerous goods vehicles on both infrastructure and Workplace…

In Australia and New Zealand, bituminous binders used in road construction are tested prior to use to ensure they will perform satisfactorily during road construction/maintenance. Some of the Australian Standards that are used for these tests have…

This test method describes the procedure for determining the cone penetration of a joint sealant at 25 

This test method describes the procedure for determining the resistance of hot poured joint sealants to flow at a temperature of 70 °