Publications

Practitioners have raised concerns when designing for heavy vehicles with respect to the combination of design values for side and longitudinal friction demand as well as design criteria for horizontal curves with adverse superelevation. This report…

Crumb rubber binders have been used to construct sprayed seals in Australia for many decades but have not been utilised in asphalt in the past. Due to the lack of crumb rubber binder grades in the Australian national polymer modified binder (PMB)…

This report describes research work into the development of a new test method utilising the dynamic shear rheometer (DSR) to conduct consistency 6% at 60 

This report documents the technical basis of the 2011 and 2019 editions of Austroads&rsquo

This report documents the technical basis of the 2010, 2012 and 2017 editions of Austroads&rsquo

This report clarified the logical architecture required to facilitate the implementation of ‘plug-in’ traffic control software, as an alternative to the control algorithm in the current controller software. The key functional requirements of an…

This report documented current activities amongst road agencies in Australia on the SCATS/STREAMS interface through the SCATS Intelligent Transport System (ITS) Port, and identified a set of 26 functional requirements for this interface to guide the…

This study examines the value and need for network-level pavement deflection data to support road asset management decisions. The outcomes of the study provide critical input to decisions to undertake network-level strength assessment across…

This report presents a review of field trials of WMA technologies conducted in various countries in the world, with the emphasis on performance differences between WMA and conventional HMA and the identification of field performance data that could…

This report describes the planning and conduct of a validation trial of three warm mix asphalt surfacings (chemical additive, polymer additive, foaming) and a hotmix asphalt ‘control’ surfacing at a site in Melbourne, Australia. Issues addressed…