Publications

This test method describes the methods for the determination of the flexural modulus, strength and fatigue characteristics of laboratory‑manufactured cemented materials using four point bending techniques.

This test method sets out the procedures for the measurement of the stress ratio of binder samples under specific conditions using the dynamic shear rheometer (DSR). A major failure mode of sprayed seals and asphalt pavements is fatigue cracking of…

This test method is for bitumen sprayers as specified in AGPT/T530 Calibration of bitumen sprayers: 

This test method sets out the procedure for validating the calibration fluid. The calibration fluid is used for volumetric calibration of bitumen sprayer pumps (AGPT/T531), and also for two methods of determining transverse distribution of bitumen…

This test method is for bitumen sprayers as specified in AGPT/T530 Calibration of bitumen sprayers: general introduction and list of methods. It sets out the procedures for determining the transverse distribution of bitumen sprayers, and is based on…

This test method is for bitumen sprayers as specified in AGPT/T530 Calibration of bitumen sprayers: general introduction and list of methods. It sets out the procedures for determining the transverse distribution of bitumen sprayers, and is based on…

This test method is for bitumen sprayers as specified in AGPT/T530 Calibration of bitumen sprayers: general introduction and list of methods. It sets out the procedures for determining the transverse distribution of bitumen sprayers, and is based on…

This test method sets out the procedure for determining the accuracy of road speed indicators used on bitumen sprayers. The road speed of the bitumen sprayer is used in conjunction with the pump volumetric output to enable bituminous materials to be…

This protocol specifies the method for sampling bituminous slurry mixture from the slurry paving unit at the paving site.

This test method sets out the procedure to evaluate the wearing resistance of bituminous slurry surfacing materials under wet abrasion conditions.