Publications

Guide to Pavement Technology Part 3 addresses the selection of the most appropriate pavement surfacing. The Guide identifies the significant factors that need to be considered in the selection of the most appropriate surfacing, their inter-…

The Engineering Guideline to Bridge Asset Management was developed to provide specific asset management guidance for road bridges. The guideline promotes an engineering approach (engineering principles, knowledge, experience and modelling tools) as…

Asset management is defined by ISO 55000 (2014) as &lsquo

Austroads has recently completed a project to review and propose improvements to the guidance on interrupted traffic flow theory contained within the Austroads Guide to Traffic Management (AGTM), Part 2 and Part 3. The updates will broaden…

Flexible granular pavements protected by sprayed seal surfacings are the backbone of the Australian and New Zealand road networks. Road agencies in Australia and New Zealand have therefore been focused on producing quality, long-lasting sprayed seal…

This report summarises activities undertaken to update guidance on interrupted traffic flow theory contained within Austroads Guide to Traffic Management Part 2 and Part 3. The updates to the guidance will enable practitioners to improve their…

This report presents the findings of site inspections and binder ageing performance studies associated with two Austroads sprayed seal trial sites constructed near Coober Pedy, South Australia and Cooma, New South Wales. These trials were…

This webinar, presented by Andrew Somers and John Wall on 6 August 2020, outlines the results of Austroads&rsquo

This webinar, presented on 13 May, identifies the skills, knowledge and behaviours drivers need, now and in the future, to safely operate cars and trucks equipped with higher levels of automation. Building on lessons learned from the aviation sector,…

This method sets out the procedure for determining the degree of stripping of a single coat sprayed seal with a nominal aggregate size of 10 mm or larger.