Publications

This protocol specifies the method for sampling bituminous slurry mixture from the slurry paving unit at the paving site.

This test method sets out the procedure to evaluate the wearing resistance of bituminous slurry surfacing materials under wet abrasion conditions.

This test method sets out the procedure to evaluate bituminous slurry materials for their propensity for binder flushing after subjecting to loaded wheel tracking cycles.

This test method sets out the method for the determination of the setting and curing characteristics of a bituminous slurry as a function of the cohesive strength developed in the mixture with time.

This test method sets out the procedure to determine the consistency of a bituminous slurry that is then used to optimise the amount of water required to form a workable mixture. This test may not be applicable to certain microsurfacing mixtures due…

This test method describes the procedure for measuring the penetration depth of a standard steel ball into a road surface under the impact of a standard hammer.

This test method sets out the procedure for determining the amount of binder drain-off likely to occur in an asphalt mix during storage and transport. The method may be used to determine the amount of binder drain-off at the maximum mixing…

This method describes the procedure for the recovery of sprayed seal samples from the pavement without disturbing the sealing aggregate orientation. The method stipulates how the void content of the sample is determined.

This test method sets out the procedure for assessing the degree of absorption of a primer or primerbinder by a given road gravel in bituminous surfacing work.

This test method details the requirements for determining the flexural stiffness, phase angle, dissipated energy per cycle, cycles to failure and cumulative dissipated energy at failure of asphalt subjected to repeated flexure by cyclical four-point…