Publications

The test method outlines the procedure for determining the permeability of a water-saturated asphalt specimen in the laboratory using the ponding method. The test method was primarily developed for dense-graded, stone mastic and gap-graded asphalt…

The Austroads Road Authority Data for Connected and Automated Vehicles (RADCAV) project studied the provision of agency-owned data to connected and automated vehicles (CAVs) addressing six high-priority data sets: roadworks, incidents, variable…

These eight reports provide guidance on the provision of agency-owned data to connected and automated vehicles (CAVs). Six high-priority data sets are addressed: roadworks, incidents, variable speed limit signs and lane control signals, static speed…

This document describes the procedures to be followed for compacting asphalt specimens using a gyratory compactor.

This webinar, presented by Robert Urquhart on 11 August 2020, gives an overview of an Austroads project which provided expert technical input into the update of four Australian standards which were revised by the Standards Australia Technical…

This method sets out the procedure for determining the degree of stripping of a single coat sprayed seal with a nominal aggregate size of 10 mm or larger.

This protocol specifies the method for sampling bituminous slurry mixture from the slurry paving unit at the paving site.

This test method sets out the procedure to evaluate the wearing resistance of bituminous slurry surfacing materials under wet abrasion conditions.

This test method sets out the procedure to evaluate bituminous slurry materials for their propensity for binder flushing after subjecting to loaded wheel tracking cycles.

This test method sets out the method for the determination of the setting and curing characteristics of a bituminous slurry as a function of the cohesive strength developed in the mixture with time.