Publications

This test method sets out the procedure to be used to prepare joint sealant samples for testing.

This test method describes the procedure for determining the degree to which a joint sealant is degraded by heat during prolonged storage (6 

The characterisation of the flexural stiffness and fatigue behaviour of bituminous mixtures in Australia and New Zealand is undertaken using a four-point bending (4PB) configuration. This document describes the procedures to be followed to verify…

This test method sets out procedures for the preparation of asphalt specimens and measuring the change in indirect tensile strength resulting from the effects of moisture and freeze/thaw conditioning. The results can be used to assess the propensity…

The test method outlines the procedure for determining the permeability of a water-saturated asphalt specimen in the laboratory using the ponding method. The test method was primarily developed for dense-graded, stone mastic and gap-graded asphalt…

A recently completed project has recommended changes to the Austroads Guide to Road Tunnels Part 2: Planning, Design and Commissioning to provide guidance on rationalising road signs on the approaches to tunnels, to divert over-height and dangerous…

This document describes the procedures to be followed for compacting asphalt specimens using a gyratory compactor.

This webinar, presented by Robert Urquhart on 11 August 2020, gives an overview of an Austroads project which provided expert technical input into the update of four Australian standards which were revised by the Standards Australia Technical…

This method sets out the procedure for determining the degree of stripping of a single coat sprayed seal with a nominal aggregate size of 10 mm or larger.

Part 13 of the Guide to Asset Management provides guidance on: (a) the establishment and maintenance of structures asset inventories and, (b) the monitoring of asset structure performance. It discusses the need for road agencies to measure asset…