Publications

This document provides a hyperlinked list of the Austroads Test Methods and Specifications.

The Australia and New Zealand Roads Capability Analysis: March 2024 Update provides a half-year update to the report published by Austroads in September 2023. It evaluates the skills and capabilities required by Austroads member agencies in the next…

This method describes the procedure for the determination of the surface texture depth of road surfaces, by the sand patch technique. This method is only applicable to surface texture depths greater than 0.3 mm. This method was developed from BS…

Join us for a webinar that delves into the latest on connected and automated vehicles (CAVs) and the pivotal role that interaction with physical infrastructure plays in their integration into our transport system. In this session, we will present a…

Following previous workforce capability studies undertaken in 2006, 2009, 2013 and 2017, Austroads engaged Oxford Economics Australia to undertake a new workforce capability analysis for member authorities based on planned and forecasted…

This report evaluates the skills and capabilities required by Austroads member agencies in the next decade to achieve their service objectives. It compares these requirements with the current and projected future workforce, identifies potential…

These guidelines set out criteria that must be addressed in any application for an automated vehicle trial. The guidelines aim to provide clear guidance on matters that should be addressed by trialling organisations as part of the trialling process…

This document describes the procedures to be followed to test an asphalt specimen using a wheel tracking test device. The procedures can be carried out on prismatic specimens that have been manufactured in the laboratory, cut from an existing…

This document describes the procedures to verify that a wheel tracking test device complies with the requirements of those devices permitted for use in Austroads test method ATM 231. The procedures are advisory rather than mandatory and reference…

The test method specifies procedures for the characterisation of the stiffness and fatigue behaviour of bituminous mixtures using a four point bending test configuration. The test procedure to characterise the complex modulus is contained in Section…