Publications

This method describes the procedure for the determination of the surface texture depth of road surfaces, by the sand patch technique. This method is only applicable to surface texture depths greater than 0.3 mm. This method was developed from BS…

This document describes the procedures to be followed to test an asphalt specimen using a wheel tracking test device. The procedures can be carried out on prismatic specimens that have been manufactured in the laboratory, cut from an existing…

This document describes the procedures to verify that a wheel tracking test device complies with the requirements of those devices permitted for use in Austroads test method ATM 231. The procedures are advisory rather than mandatory and reference…

The test method specifies procedures for the characterisation of the stiffness and fatigue behaviour of bituminous mixtures using a four point bending test configuration. The test procedure to characterise the complex modulus is contained in Section…

This test method sets out the procedure for determining the amount of binder drain-off likely to occur in an asphalt mix during storage and transport. The method may be used to determine the amount of binder drain-off at the maximum mixing…

This method describes the procedure for the recovery of sprayed seal samples from the pavement without disturbing the sealing aggregate orientation. The method stipulates how the void content of the sample is determined.

This test method sets out the procedure for assessing the degree of absorption of a primer or primerbinder by a given road gravel in bituminous surfacing work.

This test method details the requirements for determining the flexural stiffness, phase angle, dissipated energy per cycle, cycles to failure and cumulative dissipated energy at failure of asphalt subjected to repeated flexure by cyclical four-point…