Publications

This report details investigations that were conducted to verify the new Austroads sprayed seal design guidelines.

To verify the appropriateness of the proposed basic voids factor (Vf), and the initial sealing design approach (and also to validate…

EME2 mixes are produced using a hard paving grade bitumen applied at a high binder content (approximately 6%). Compared to conventional asphalt bases with unmodified binders, EME2 asphalt is characterised by high stiffness, high durability, superior…

This report presents an extensive literature review of pavement surface texture measurement methods with a specific interest in how they affect operator safety and delays to traffic. The literature review shows that there are a number of methods in…

In 1993, Austroads performed an extensive trial of foamed bitumen sprayed sealing in Australia, as a part of environmental and energy effective sealing technology development program. The trials were conducted in various states and reported to be…

This report reviewed overseas and Australian experience in using bitumen emulsions. Increasing economic and environmental pressures have induced an increase in demand for the use of bitumen emulsions overseas. However, emulsion sprayed seals are…

A review of bleeding or flushed seals was undertaken to determine what physical changes had taken place within the seal that had resulted in the binder lying at or close to the surface. The evaluation process used a visual appraisal and a digital…

This publication describes the development of the flexible overlay design procedures included in the Austroads Guide to Pavement Technology Part 5: Pavement Evaluation and Treatment Design. The origins of two procedures are detailed: a design chart…

The study involved a laboratory assessment of two cemented materials to assess their strength, modulus and fatigue properties. The cemented materials consisted of a hornfels crushed rock and a quartzite siltstone bound with general purpose cement at…

This report presents the results of testing conducted on an unbound granular pavement with a thin bituminous surfacing using a variety of tyre types and half-axle loads applied using the Accelerated Loading Facility. It was found that the reference…

This document provides advice for users designing asphalt mixes using the Austroads mix design procedures. The advice given should enable users to produce repeatable and valid results. The tests covered in this document are