Publications

The addition of a small amount of cementitious binder to non-standard granular materials may result in a fit for purpose base or subbase at a significantly lower cost than crushed rock complying with standard specifications. Such lightly bound…

Flexible granular pavements protected by sprayed seal surfacings are the backbone of the Australian and New Zealand road networks. Road agencies in Australia and New Zealand have therefore been focused on producing quality, long-lasting sprayed seal…

There is a need to improve Austroads procedures for the structural design of pavements containing lightly bound cemented (LBC) materials. This report describes the findings of an investigation of the performance of Queensland pavements with LBC…

This report presents the findings of site inspections and binder ageing performance studies associated with two Austroads sprayed seal trial sites constructed near Coober Pedy, South Australia and Cooma, New South Wales. These trials were…

This webinar, presented by Robert Urquhart on 11 August 2020, gives an overview of an Austroads project which provided expert technical input into the update of four Australian standards which were revised by the Standards Australia Technical…

This webinar, presented on 30 June 2020 by Zia Rice, Tyrone Toole and Lory Noya, looks specifically into the use of the life-cycle costing framework and the important components that are considered for the assessment of an unsealed road. Special…

This session, facilitated by Tyrone Toole, Phil Hunt and Ranita Sen on 17 June 2020, focuses on the life-cycle costing framework and a suite of practical examples to demonstrate how to assess the best use of available marginal and non‑standard…

This webinar, presented by Zia Rice and Phil Hunt on 2 June 2020, is the first one in a series of three online sessions to extend practitioners&rsquo

This method sets out the procedure for determining the degree of stripping of a single coat sprayed seal with a nominal aggregate size of 10 mm or larger.

Austroads Technical Specification ATS 3480 sets out the requirements for the following treatments to the surface of bituminous pavements: improving the surface texture of sprayed seals by removing excess binder (&lsquo